Fig. 8.—Withe.
Fig. 9.—Withe in Place.
A fence which is cheaply constructed in a timbered region, and calls for no outlay whatever, besides labor, is illustrated at figure 7. The posts are set in a straight line, having previously been bored with an inch augur to receive the pins. When they are set, the pins are driven diagonally into the posts, and the poles laid in place. It would add much to its strength, if the poles were laid so as to “break joints.” A modification of this fence is sometimes made by using withes instead of pins to hold the poles in place. The withe is made of a young sapling or slender limb of beech, iron-wood, or similar tough fibrous wood, with the twigs left on. This is twisted upon itself, a strong loop made at the top, through which the butt is slipped. When in place, the butt end is tucked under the body of the withe.
FENCES FOR SOIL LIABLE TO HEAVE.
Fig. 10.—End View Of Fence.
Fig. 11.—Side View Of Fence.
The main point in such a fence is either to set the posts and place a pin through them near the bottom, so that the frost may not throw them out, or to so attach the boards that the posts may be re-driven, without splitting them, or removing the rails from the fence. The latter is, perhaps, the best plan, and may be accomplished in several ways, the most desirable of which is shown in figures 10 and 11. The post, h, is driven in the usual manner, when a strip of board, g, is fastened to it by three or four spikes, depending upon the hight of the fence. A space just sufficient to insert the ends of boards a, e, figure 11, is left between the post and outside strip, the ends of the boards resting upon the spikes. Many miles of this fence are in use. It looks neat; besides any portion is easily removed, making a passage to and from the field. A new post is easily put in when required, and any may be re-driven when heaved by the frost.
Fig. 12.—Fence With Iron Hooks.
Where iron is cheap, a rod about three-eighths of an inch in diameter is cut in lengths of about seven and a half inches; one end is sharpened, while the opposite end, for three inches, is bent at right angles. After the boards are placed in position, the hooks should be driven in so that they will firmly grasp the boards and hold them in place. The general appearance of the finished fence is shown in figure 12, and is one adapted to almost any locality.
Fig. 13.—Horizontal Section.
A much better method is to fasten the boards temporarily in place, and then bore a half inch hole through both boards and the post, into which a common screw bolt is then inserted and the nut screwed on firmly. The two ends should, however, be put on opposite sides of the post. One bolt thus holds the ends of both boards firmly to the post, as shown in figure 13. With this style of fence, old rails or round poles may be used instead of boards.
OTHER PRIMITIVE FENCES.
In the heavily timbered parts of the country, where the settlers a few years ago were making farms by felling and burning the huge pine trees, a fence was constructed like the one shown in figure 14. Sections of trees, about four and a half feet long and often as thick, were placed in line and morticed to receive from three to five rails. This style of fence could be used by the landscape gardener with fine effect for enclosing a park or shrubbery.
Fig. 14.—Log Posts.
In the same regions, when a farmer has pulled all the stumps from a pasture that slopes toward the highway, the stumps may be placed in line along the road with the top ends inside of the field. The gaps between where the stumps cannot be rolled close together, are filled with brushwood. A portion of this fence is shown in figure 15.
Fig. 15.—Stump Fence.
Fig. 16.—Wicker Fence.
Where other material is costly, or not to be obtained, the wicker fence, constructed of stakes and willows, is much used. In the far West it is to be seen in every town, generally built on a small embankment of earth from one to two feet deep. In this climate, with occasional repairs, it lasts from ten to fifteen years. Figure 16 shows the style of construction.
Fig. 17.—Brush Fence.
Throughout the forest regions is found the staked and ridered brush growing on the line where the fence is constructed. Figure 17 illustrates a few rods of brush fence—such fencing being met with in our Southern States.
CHAPTER II.
STONE AND SOD FENCES.
HOW A STONE WALL SHOULD BE BUILT.
Fig. 18.—Well Laid Wall.
To build a stone wall, some skill is required. The foundation should be dug out a foot deep, and the earth thrown upon each side, which serves to turn water from the wall. Large stones are bedded in the trench, and long stones placed crosswise upon them. As many whole stones as possible should be used in this place. The stones are then arranged as shown in the engraving, breaking joints, and distributing the weight equally. Any small spaces should be filled with chips broken off in dressing the larger stones, so as to make them fit snugly. As it is a work that will last a century, it is worth doing well.
BUILDING A STONE FENCE.
Fig. 19.—Laying Up A Stone Fence.
A permanent stone fence