9 Chapter 9Figure 9.1 Typical time evolution of the
and signals (dots) at the initial...Figure 9.2 Computed initial versus applied electric field data (spots) in ....Figure 9.3 Output phase‐shift versus applied electric field ( ) data (circle...Figure 9.4 Fringe‐locked running hologram speed versus applied electric field ...Figure 9.5 Fringe‐locked running hologram experiment: frequency detuning (me...Figure 9.6 Fringe‐locked running hologram experiment on undoped crystal usin...Figure 9.7 and experimentally measured as function of on an undoped cr...Figure 9.8 3D plotting of experimentally measured and as function of fro...Figure 9.9 3D surface plotting of and as function of from Eq. 9.19 with ...Figure 9.10 Characterization of reduced :Fe (labeled LNB3): self‐stabilized h...Figure 9.11Figure 9.11 Characterization of reduced :Fe (labeled LNB5): self‐s...Figure 9.12 Characterization of oxidized :Fe (labeled LNB1): self‐stabilized ...10 Chapter 10Figure 10.1 Schematic diagram of the experimental holographic setup: PBS: pola...Figure 10.2Figure 10.2 (a) Lateral view of the holographic setup: CCD camera (...Figure 10.3 Simplified schema showing the distribution of incident light (
) b...Figure 10.4 Optimization of the target illumination: , diffracted reference b...Figure 10.5 Loudspeaker membrane (left) driven at 3.0 kHz and analyzed by the ...Figure 10.6 Amplitude of vibration at a point of local maximum in the membrane...Figure 10.7 Amplitude of vibration at two different points of local maximum in...Figure 10.8 Time‐average holographic interferometry pattern of a thin phosphor...Figure 10.9Figure 10.9 Time‐average holographic interferometry pattern of a th...Figure 10.10 Time‐average holographic interferometry pattern of a thin phospho...Figure 10.11 Double exposure holographic interferometry of a tilted rigid plat...Figure 10.12 Double exposure holographic interferometry of a rigid plate that ...Figure 10.13 Double exposure holographic interferometry of a rigid plate that ...11 Chapter 11Figure 11.1 Experimental setup: S: massive copper cylinder with temperature‐co...Figure 11.2 Evolution of
and during high temperature self‐stabilized holog...Figure 11.3 Diffraction efficiency of the overall grating during white‐light d...12 1Figure 1 Naturally birefringent uniaxial lithium niobate crystal view under co...
13 2Figure B.1 Diffraction efficiency as a function of out‐of‐Bragg angle
in mra...Figure B.2 , computed from Eq. B.15, as a function of for in‐Bragg conditio...Figure B.3 Measurement of diffraction efficiency: The recording beams are not ...14 3Figure C.1 Effective field coefficient: the figure shows a Gaussian cross‐sect...
15 4Figure D.1 Volume
with fixed ions of volume density of characteristic coll...16 5Figure E.1 np‐junction showing the depletion layer and a diagram of the Schott...Figure E.2 np‐junction showing the depletion layer including the intrinsic lay...Figure E.3Figure E.3 pn‐junction showing the depletion layer including the int...Figure E.4 Photovoltaic mode operation for photodiodes. A shows its operation ...Figure E.5 Photoconductive mode operation for photodiodes. A reverse bias volt...Figure E.6 Operational amplifier operated photodiode in the short‐circuit phot...