The dynamo for the generation of the electric current demands exactly the opposite class of conditions. We may therefore surmise that the windmill of the future, as constructed for the purposes of storing power, will have a long barrel upon which will be set numerous very short blades or sails. Reducing this again to its most convenient form, it is plain that a spiral of sheet-metal wound round the barrel will offer the most convenient type of structure for stability and cheapness combined. At the end of this long barrel will be fixed the dynamo, the armature of which is virtually a part of the barrel itself, while the magnets are placed in convenient positions on the supporting uprights. From the generating dynamo the current is conveyed directly to the storage batteries, and these alone work the electric motor, which, if desired, keeps continually in motion, pumping, grinding, or driving any suitable class of machinery.
It is rather surprising to find how relatively small is the advantage possessed by the vane-windmill over the fixed type in the matter of continuity of working. During about two years the Author conducted a series of experiments with the object of determining this point, the fixed windmill being applied to work which rendered it a matter of indifference in which way the wheel ran. With the prevailing winds from the west it ran in one direction, and with those of next degree of frequency, namely from the east, it turned in the reverse direction. The mill, however, was effective although the breeze might veer several points from either of the locations mentioned. It was found that there were rather less than one-fourth of the points of the compass, the winds from which would bring the wheel to a standstill or cause it to swing ineffectively, but as these were the directions in which the wind least frequently blew it might safely be reckoned that not one-eighth of the possible working hours of a swivel-windmill were really lost in the fixed machine.
With the type adapted to the working of a dynamo as already described, it will, in most cases, be convenient to construct two spirals on uprights set in three holes in the ground, forming lines at right angles to each other, but both engaging, by suitable gearing, with the electric current generator situated at the angle. This will be found cheaper than to go to the expense of constructing the mill on a swivel so that it may follow the direction of the wind. At the same time it should be noticed that the adoption of the high speed wind-wheel, consisting of some kind of spiral on a very long axis, may be made effective for improving even the swivel windmill itself, so as to adapt it for electric generation and conservation of power through the medium of the storage battery. Supposing that a number of small oblique sails be set upon an axis lying in the direction of the wind, the popular conception of the result of such an arrangement is that the foremost sails would render those behind it almost, if not entirely, useless.
The analogy followed in reaching this conclusion is that of the sails of a ship, but, as applied to wind-motors, it is quite misleading, because not more than one-third or one-fourth of the energy of the wind is expended upon the oblique sails of an ordinary wind-wheel. Moreover, in the case of a number of such wheels set on a long axis, one behind the other as described, the space within which the shelter of the front sail is operative to keep the wind from driving the next one is exceedingly minute.
The elasticity of the air and its frictional inertia when running in the form of wind cause the current to proceed on its course after a very slight check, which in point of time is momentary and in its effects almost infinitesimal. This being the case, and the principal expense attendant upon the construction of ordinary wind-engines being due to the need for providing a large diameter of wind-wheel, with all the attendant complications required to secure such a wheel from risk, it is obvious that as soon as the long axis and the very short sail, or the metallic spiral, have been generally introduced as adjuncts to the dynamo storage battery, an era of cheaper wind-motors will have been entered upon—in fact, the "little want" of which Lord Kelvin spoke in 1881 will have been supplied. The high speed which the dynamo requires, and the more rapid rate at which windmills constructed on this very economical principle must necessarily run, both mark the two classes of apparatus as being eminently suited for mutual assistance in future usefulness.
The anemometer of the "Robinson" type, having four little hemispherical cups revolving horizontally, furnishes the first hint of another principle of construction adapted to the generation of electricity. Some years ago a professor in one of the Scottish Universities set up a windmill which was simply an amplified anemometer, and connected it with several of Faure's storage batteries for the purpose of furnishing the electric light to his residence. His report regarding his experience with this arrangement showed that the results of the system were quite satisfactory.
In this particular type of natural motor the wind-wheel, of course, is permanently set to run no matter from what direction the wind may be blowing. Tests instituted with the object of determining the pressure which the wind exerts on the cup of a "Robinson" anemometer have shown that when the breeze blows into the concave side of the cup, its effect is rather more than three times as strong as when it blows against the convex side. At any given time the principal part of the work done by a windmill constructed on this principle is being carried out by one cup which has its concave side presented to the wind, while, opposite to it, there is another cup travelling in the opposite direction to that of the wind but having its convex side opposed.
The facts that practically only one sail of the mill is operative at any given time, and that even the work which is done by this must be diminished by nearly one-third owing to the opposing "pull" of the cup at the opposite side, no doubt must detract from the merits of such a wind-motor, judged simply on the basis of actual area of sail employed. But when the matter of cost alone is taken as the standard, the advantages are much more evenly balanced than they might at first sight seem to be.
The cup-shaped sail may be greatly improved upon for power-generating purposes by adopting a sail having a section not semicircular but triangular in shape, and by extending its length in the vertical direction to a very considerable extent. Practically this cheap and efficient wind-motor then becomes a square or hexagonal upright axis of fairly large section, to each side of which is secured a board or a rigid sheet-metal sail projecting beyond the corners. The side of the axis and the projecting portion of the sail then together form the triangular section required.
For the sake of safety in time of storm, an opening may be left at the apex of the angle which is closed by a door kept shut through the tension of a spring. When the wind rises to such a speed as to overbalance the force of the spring each door opens and lets the blast pass through. One collateral advantage of this type of windmill is that it may be made to act virtually as its own stand, the only necessity in its erection being that it should have a collar fitting round the topmost bearing, which collar is fastened by four strong steel ropes to stakes securely set in the ground. The dynamo is then placed at the lower bearing and protected from the weather by a metal shield through which the shaft of the axis passes.
For pumping, and for other simple purposes apart from the use of the dynamo, a ready application of this form of wind-engine with a minimum of intricacy or expense may be worked out by setting the lower bearing in a round tank of water kept in circular motion by a set of small paddles working horizontally. Into the water a vertically-working paddle-wheel dips, carrying on its shaft a crank which directly drives the pump. This simple wind-motor is particularly safe in a storm, because on attaining a high speed it merely "smashes" the water in the tank.
Solar heat is one of the principal sources of the energy to be derived from the wind. Several very determined and ingenious attempts at the utilisation of the heat of sunshine for the driving of a motor have been made during the past century. As a solution of a mechanical and physical puzzle, the arrangement of a large reflector, with a small steam-boiler at the focus of the heat rays thrown by it, is full of interest. Yet, when a man like the late John Ericsson, who did so much to improve the caloric engine, and the steam-ship as applied to war-like purposes, meets with failure in the attempt to carry such an