On fewer occasions, a new topography and a confined river is created by rifting, as shown by the Rio Grande, which is a pull-apart system that began in the early Miocene and developed from separate shallow basins to an integrated system. The failed arm at a plate tectonics triple junction also may give rise to rifting which may carry a big river that occupies the long, narrow, deeply filled depression extending into a craton. At the other end of the linear depression, the river builds a delta at the plate boundary marking the edge of the continent. The Niger is an example. Another example is the Blue Nile which rises within the rift system of Ethiopia to flow through a deep gorge for about half of its length.
A new topography and a modified river may also be formed off a mantle plume (Cox 1989) when it rises to create an extensive domal surface with high elevation, as happened in several parts of the Earth during the Late Cretaceous. Certain areas were uplifted by doming and magmatic underplating, giving rise to topographic highs and new drainage systems. The Orange and part of the Zambezi River are examples.
Not all large rivers fall into such clearly generalised classes. Some do not rise from currently active orogenic belts but drain parts of old mountains that have some elevation or are only slightly active tectonically. Tandon and Sinha (2007) described such rivers as located in cratonic settings as these drain major cratons. Examples of this type are the Mississippi, Yukon, Yenisei, Lena, and Ob. Potter (1978) stated that four major morphological patterns may cover the majority of large rivers. These can be described as:
1 (1) Most sediment derived from mountains marginal to a large craton (the Amazon).
2 (2) The river flowing marginal and parallel to a fold belt (the Ganga).
3 (3) A big river flowing along the strike of a mountain range (the Mekong).
4 (4) A river superimposed across multiple mountain chains (the Danube).
Potter proposed a fifth possibility which may have occurred in the past: a river on a large craton without bordering mountains (Potter 1978).
2.3 Smaller Tectonic Movements
The basin and the channel of a big river are further modified by smaller tectonic disturbances. For example, the Lower Amazon crosses several transverse structures in its course (Figure 2.1). In the downstream direction these are the Iquitos Arch, Jutai Arch, Purus Arch, Mont Alegre Intrusion and Ridge, and Gurupa Arch. When the Amazon crosses such structural highs, certain geomorphic features characterise the river (Mertes and Dunne 2007). The channel runs straight, its floodplain remains relatively narrow, scroll bars are found only near channel margins, and migration of the channel is limited. In contrast, wide floodplains with significant river movement, scroll bars and anabranches distinguish the river flowing on a low gradient between the upwarps. Even when covered by an alluvial fill, these upwarps affect the river. The morphology of a large river therefore varies along its course.
Large-scale fractures also regionally affect the tributary network in the Amazon Basin. Deep-seated basement fracturing appears to have disturbed the overlying sedimentary rocks that affect the drainage net, oriented in northeast and northwest directions (Potter 1978, Figure 8 and references therein; Mertes and Dunne 2007). The alignment of the Lower Negro, one of the major north bank tributaries of the Amazon, has been interpreted as controlled by a NW-SE tectonic lineament (Franzinelli and Igreja 2002). Here sunken crustal blocks and depressions occur along a half-graben, submerged to approximately 20 m with a width of up to 20 km. This controls the pattern of river islands, bars, and the location of sediment storage in the river.
Figure 2.1 Schematic illustration of the relation between structure and morphology, the Lower Amazon Valley. The vertical bars show the approximate location of arches and a tilted block which are structural highs: JA, Jutai Arch; PA, Purus Arch; MI, Monte Allegro Intrusion and Ridge; GA, Gurupa Arch; TFB, approximate location of a tilted fault block.
Source: Mertes and Dunne 2007 and references therein.
Figure 2.2 Longitudinal profile of the Nile over varying regional structures and lithology.
Source: Woodward et al. 2007, from Said 1994.
A number of rivers flow along the structural grains of a folded mountain belt almost to their mouths. The Mekong and Salween are good examples. The Mekong flows for about 80% of its length in a narrow valley flanked by ridges (Figure 1.2a) whereas the Salween flows through a series of gorges. The lower Irrawaddy crosses three gorges in rock separated by wider basins in alluvium, and the morphology and behaviour of the river change between the gorges and basins. The entry and exit to the gorges show adjustment of the river over a short distance. The Irrawaddy finally continues through a flat lowland, discharging into the Gulf of Martaban through a large delta. The entire river is thus a sum of its different parts. The morphology and structural underpinning of large rivers are further discussed in Chapter 4.
Large rivers differ in their form and function, and for many rivers the understanding of such differences is achieved via a history of continental plate tectonics and lesser tectonic movements. The longitudinal profile of large rivers generally reflects a combination of their tectonic settings, basin lithology, and erosional history as their gradient changes (Figure 2.2). The profile of a large river over a long distance thus may be a combination of different sections. Geological structure and lithology tend to control the basic characteristics of the rivers.
2.4 The Subsurface Alluvial Fill of Large Rivers
The rock surface underlying the alluvial valley-fill of a large river generally is not smooth but marked by irregularities such as ribs, furrows, scour holes, etc. Schumm, for example, discussed the variable thickness of the Mississippi Valley alluvium at East St. Louis, Missouri as reported in the literature. The thickness of the alluvium reaches approximately 35–50 m in places (Schumm 1977). The depth of the alluvium and its nature are exhibited in boreholes, but a complete mapping is very difficult. Detailed three-dimensional studies have been carried out on several rivers (Fielding 2007). Construction of dams over large rivers also exposes surface morphology. The section at Hoover Dam on the Colorado River disclosed an inner channel flanked by bedrock terraces. About 200 km of the channel of the Changjiang were mapped between November 1978 and May 1979 near the site chosen later for the construction of the Three Gorges Dam. More than 90 troughs were found at the bottom of the river, cumulatively covering 45% of the total length of the river mapped. All the troughs were more than 40 m below the lowest river level (Yang et al. 2001). The cross-section of the channel of the Upper Mekong is trapezoidal, or has a deep inner channel bounded by rock benches, or a wide scabland-like section with rock ribs and piles rising from the bed (Figure