LaFosse & Alexander's Origami Jewelry. Richard Alexander

the Square Bead may be covered. The decorative effect of this cover is to make a clean tile out of the Square Bead, without the diagonal delineation. Functionally, this cover makes tiled arrays of Square Beads look clean and elegant by canceling the wirework.

      1. Measure the length of the Square Bead you wish to cover, and then trim the square cover paper to be 1½ times as long.

      2. Beginning with the non-display side up, valley-fold in half diagonally both ways, unfolding after each. Make only short creases, just enough to mark the center of the square.

      3. Valley-fold each of the four corners to the center where the creases cross. Unfold.

      4. Apply paste to the inside of each of the four triangular flaps of the framing paper. Tuck each of the four corners into the open pockets at the edges of the Square Bead. Notice that you could paste an eye pin (A) or insert a stringing cord (B).

      5. The completed single Square Bead Mounting Cover, front and back. You could also apply a second cover to the other side.

      Tile Bib Necklace

      6. Make two strands each of graduated sizes of Square Beads, connect diagonally using beading wire and glue.

      7. Arrange the strands as shown. (A) Paste the horizontal cords in place. Let dry completely. (B) Paste an eye pin on each of the two top, outermost squares, indicated with an “X” arrowhead. (C) Apply a Mounting Cover to the back of each Square Bead. Let dry completely.

      8. Turn over.

      9. The completed tiled Bib with eye pins, ready for mounting to a neck chain.

      Pillow Beads

      Designed by Michael G. LaFosse from traditional bases