Camp Life in the Woods and the Tricks of Trapping and Trap Making - The Original Classic Edition. Gibson W

and particularly so when the Puma is the victim sought. In our illustration we see the trap as it appears when set, and the same precaution of aiming at some tree should be exercised as advise with the gun trap. The bow should first be secured in place directly beneath and one eighth of an inch from the edge of the hole in the board, as seen at (a). Two large wire staples may be used for this purpose, being passed over the bow through holes in the board and clinched on the opposite side. The bend of the bow and length of string should now be determined, one end of the latter being attached to the tip of the bow and the other end supplied with a loop. The board should then be driven into the ground to the depth of about eight inches. We will next take up the arrow. Pass the barb through the hole in the board and adjust the notch over the bow-string, draw the arrow back and release the string. If the arrow slide easily and swiftly, through the board, keeping true to its aim, the contrivance is in perfect working order and is ready to be set. This is accomplished by the very simple and ingenious mechanical arrangement, shown at (b). On the under side of the arrow just behind the barb, a flat notch one eighth of an inch in depth and two and a half inches in length is cut, with rounded ends, as seen

       in the illustration. The bait stick should consist of a sapling about three feet in length, the large end being trimmed so Page 25 as to fit in the hole over the arrow while the notch in the latter rests in the bottom of the aperture as seen in the illustration (b). The trap may then be set. Draw back the arrow, until the notch rests in the hole in the board. Insert the bait stick very lightly above the arrow as shown at (b), propping it in place at the angle seen in the main drawing. The bait for a puma should consist of a portion

       of some carcass, or if for other animals, any of the baits given in our section on "trapping" may be used. In order to secure the bait firmly to the bait stick, a small hole and a peg at the side of the baited end will effectually prevent its removal and the trap will thus most surely be sprung. The prop which sustains the bait stick need be only a small crotch inserted a little to one side of the trap.

       The bow should now be surrounded by a wide pen, allowing room for the spring of the ends. The top of the enclosure should also be guarded by a few sticks or branches laid across. Directly in front of the trap and extending from it, a double row of rough stakes three feet high should be constructed, thus insuring an approach in the direct range of the arrow. Without this precaution the bait might be approached from the side, and the arrow pass beneath the head of the animal, whereas on the other hand it is sure to take effect in the neck or breast of its victim. Of course the success of this trap depends entirely upon the strength of the bow. When a large and powerful one is used its effect is almost surely fatal.

       Another form of the bow trap, much used in the capture of the tiger, forms the subject of our next illustration: no bait is here used. The trap is set at the side of the beaten path of the tiger and is sprung by the animal pressing against a string in passing. The bow

       is large and powerful and is secured to two upright posts about eight inches apart. The string is drawn back and a blunt stick is then inserted between the bow string and the inside centre of the bow, thus holding the latter in a bent position. A stout stick, with a flattened end is next inserted between the end of the blunt stick and the inside of the bow, the Page 26 remaining part of the stick extending downwards, as our illustration shows. To the lower end of this stick a string is attached and carried across the path in the direct range of the arrow, being secured to a stake on the opposite side. The arrow is generally barbed with a steel or flint point,

       and wound with thread saturated with a deadly poison. This is now rested on the top of the bow between the upright parts, and its notch caught in the bow-string. Everything is then in readiness. The tiger soon steals along his beaten track. He comes nearer and nearer the trap until at last his breast presses the string. Twang, goes the bow and the arrow is imbedded in the flesh of its victim. He writhes for a few moments, until he is released from his torments by the certain death which follows the course of the poison through his veins.

       The use of the poison is very dangerous: a mere scratch through the skin is likely to prove fatal, and the trapper is thus likely to prove his own victim. Poisoned arrows are little used by trappers; and the bow trap, when properly constructed, is sufficiently effective without the venom.

       THE DOWN-FALL.

       This is the famous harpoon trap, so commonly used in Africa for the capture of the hippopotamus. There is no reason why Page 27

       it may not be successfully employed in our own country for taking large game, or modified on a reduced scale for smaller animals.

       The hippopotamus makes his daily rounds in regular beaten pathways; and the trapper, knowing this peculiarity, turns it to advantage. This is a common habit with many animals; and these "runways" are easily detected by the matted leaves and grass and the broken twigs. Over such a beaten track the harpoon-trap is suspended.

       The harpoon used by the native African trappers somewhat resembles a double-barbed arrowhead, and has a reflexed prong on the shaft just behind the barbs,--a sort of combination between a spear and a fish-hook. It is a terrible weapon; and, when once launched into the flesh of its victim, its withdrawal is impossible, on account of the reflexed barb. Any sharp steel shaft will answer the purpose of the harpoon; it should be eight or ten inches in length, and filed to a keen point. We will now construct the trap. The first requisite is a straight section of the branch of some tree. This should be about four inches in diameter, and four feet in length. Into one end of this beam the harpoon should be firmly imbedded, allowing the point to project about six inches. This beam should then be Page 28 weighted with two large stones, attached firmly by a rope, about eighteen inches above the harpoon. At about six

       11

       inches from the other end of the log a notch should be cut, having its flat side uppermost, as shown plainly in our illustration. The

       implement is now ready.

       Select some favorably situated tree, whose branches extend over the pathway chosen for the trap. By the aid of a rope secured to the log, and thrown over the limb, the weighted beam may be drawn up into the tree. While thus held by a person below, the trapper should climb the tree to complete operations. For this purpose, a smaller branch about three feet in length should be cut. One end should be flattened off on both sides, so as to fit in the notch in the beam; and the part which rests on the limb, as seen in the illustration, should also be flattened to prevent turning. A piece of stout Indian twine should next be fastened to the unwhittled end

       of the stick, which may then be adjusted in the notch of the harpoon beam, as seen in the engraving. The string may then be thrown

       down, and grasped by the companion below, who holds it firmly, after which the original rope may be removed. It will be noticed

       that the weight of the harpoon and accompaniments rests on the short arm of the lever which passes over the limb of the tree,

       and the tension on the string from the long arm is thus very slight. This precaution is necessary for the perfect working of the trap. To complete the contrivance, a small peg with a rounded notch should be cut, and driven into the ground directly plumb beneath the long end of the lever. It should be inserted into the earth only sufficiently to hold the string without pulling out, and the side

       of the notch should face the path; its height should be about a foot. Into the notch the string should be passed, being afterwards drawn across the path and secured on the opposite side at the same height. The trap is now set; and woe to the unlucky quadruped that dares make too free with that string! A very slight pressure from either side is equally liable to slip the string from the notch, or loosen the peg from the ground; and the result is the same in either case,--down comes the weighted harpoon, carrying death and destruction to its victim.

       For large animals, this mode of setting will be found to work perfectly. When constructed on a smaller scale, it may be slightly modified. It will be noticed that, when the string is approached from one side, it is merely slipped out of the notch,--a slight pressure being sufficient to dislodge it,--while the pressure Page 29 from the opposite direction must be strong enough to lift the peg out of the ground bodily. This is easily done when the peg is lightly inserted; but, to insure success, even with light pressure from either side, an additional precaution may be used, if desired. Instead of fastening the