The Cook and Housekeeper's Complete and Universal Dictionary; Including a System of Modern Cookery, in all Its Various Branches, Adapted to the Use of Private Families. Eaton Mary

to ascertain the proper time for boiling the liquor, lade out some of it; and if a working be discovered, and the hops are sinking, the wort is boiled enough. Long and slow boiling injures and wastes the liquor. As soon as it is sufficiently boiled, run the liquor through a cloth or fine sieve into some coolers, to free it from the hops, and to get a proper quantity cooled immediately to set it to work. If the brewhouse be not sufficiently airy to cool a quantity soon, the liquor must be emptied into shallow tubs, and placed in a passage where there is a thorough draught of air, but where it is not exposed to rain or wet. The remainder in the copper may then be let into the first cooler, taking care to attend to the hops, and to make a clear passage through the strainer. The hops must be returned into the copper, after having run off four or five pailfuls of the liquor for the first cooling, and then it must be set to work in the following manner. Take four quarts of yeast, and divide half of it into small wooden bowls or basons, adding to it an equal quantity of wort nearly cold. As soon as it ferments to the top of the basons, put it into two pails; and when that works to the top, distribute it into two wide open tubs. Fill them half full with cool wort, and cover them over, till it comes to a fine white head. This will be accomplished in about three hours, and then both quantities may be put together into the working tub, with the addition of as much wort as is sufficiently cooled. If the weather be mild and open, it cannot be worked too cold. If the brewing be performed in frosty weather, the brewhouse must be kept warm; but hot wort must never be added to keep the liquor to a blood heat. Attention also must be paid to the quality of the yeast, or it may spoil all the beer. If it has been taken from foxed beer, or such as has been heated by ill management in the working, it will be likely to communicate the same bad quality. If the yeast be flat, and that which is fresh and lively cannot be procured, put to it a pint of warm sweetwort of the first letting off, when it is about half the degree of milk-warm. Shake the vessel that contains it, and it will soon gather strength, and be fit for use. – Tunning is the last and most simple operation in the business of brewing. The casks being well prepared, perfectly sweet and dry, and placed on the stand ready to receive the liquor, first skim off the top yeast, then fill the casks quite full, bung them down, and leave an aperture for the yeast to work through. If the casks stand on one end, the better way is to make a hole with a tap-borer near the summit of the stave, at the same distance from the top as the lower tap-hole is from the bottom. This prevents the slovenliness of working the beer over the head of the barrel; and the opening being much smaller than the bung-hole, the beer by being confined will sooner set itself into a convulsive motion, and work itself fine, provided proper attention be paid to filling up the casks five or six times a day. – Another method of brewing, rather more simple but not more excellent than the above, may be adopted by those whose conveniences are more limited. For table beer, allow three bushels of malt to thirty-nine gallons of water, and a pound and a half of hops. Pour a third part of the hot water upon the malt, cover it up warm half an hour, then stir up the mash, and let it stand two hours and a half more. Set it to drain off gently; when dry, add half the remaining water, mash, and let it stand half an hour. Run that into another tub, and pour the rest of the water on the malt; stir it well, cover it up, and let it infuse a full hour. Run that off and mix all together. Put the hops into a little hot water to open the pores, then put the hops and water into the tub, run the wort upon them, and boil them together for an hour. Strain the liquor through a coarse sieve, and set it to cool. If the whole be not cool enough that day to add to it the yeast, a pail or two of wort may be prepared, and a quart of yeast added to it over night. Before tunning, all the wort should be put together, and thoroughly mixed. When it has done working, paste a piece of paper on the bung-hole, and after three days it may be fastened close. In less than a month the beer will be fit for use. See Ale, Malt, Beer.

      BREWING UTENSILS. The most desirable object in the process of brewing is the fixing of the copper, so as to make the fire come directly under the bottom of it. Many coppers are injured, and rendered unserviceable, for want of proper attention to this particular. The method adopted by the most experienced bricklayers is to divide the heat of the fire by a stop; and if the door and the draft be in a direct line, the stop must be erected from the middle of each outline of the grating, and parallel with the centre sides of the copper. The stop is nothing more than a thin wall in the centre of the right and left sides of the copper, ascending half way to the top of it; on the top of which must be left a small cavity, four or five inches square, for a draft of that half part of the fire which is next to the copper door, to pass through, and then the building must close all round to the finishing at the top. By this method of fixing the copper, the heat will communicate from the outward part of the fire round the outward half of the copper through the cavity; as also will the furthest part of the fire, which contracts a conjunction of the whole, and causes the flame to slide gently and equally all round the bottom of the copper. Considerable advantages result from this position of the copper. If the draught under it were suffered at once to ascend, without being thus divided, the hops would be scorched in the boiling, and liable to stick to the sides, which would considerably injure the flavour of the liquor, unless kept continually stirring. It will also save the consumption of fuel, and preserve the copper much longer than any other method, as there will be no difficulty in boiling half a copper full at a time without doing it any injury. – The next article of consideration in this case is the Mash-tub. This should be proportioned to the size of the copper, and the quantity of beer intended to be brewed. The grains should not be kept in the tub any longer than the day after brewing, as in hot weather especially the grains begin to turn sour as soon as they are cold; and if there be any sour scent in the brewhouse at the time the liquor is tunned, it will be apt to injure the flavour of the beer. – Tubs and Coolers require to be kept perfectly sweet and clean, and should not be used for any other purpose. In small houses, where many vessels are cumbersome and inconvenient, it is too common to use the same tubs for both washing and brewing; but this ought not to be done where it can be avoided; and where it is unavoidable, the utmost care is necessary to give them a double washing, scouring, and scalding. Coolers also require considerable care, or by the slightest taint they will soon contract a disagreeable flavour. This often proceeds from wet having infused itself into the wood, it being apt to lodge in the crevices of old vessels, and even infect them to such a degree, that it cannot be removed, even after several washings and scaldings. One cause incidental to this evil is, using the brewhouse for the purposes of washing, which ought never to be permitted, where any other convenience can be had; for nothing can be more injurious than the remains of dirty suds, left in vessels intended for brewing only. Nor should water be suffered to stand too long in the coolers, as it will soak into them, and soon turn putrid, when the stench will enter the wood, and render them almost incurable. More beer is spoiled for want of attention to these niceties than can well be imagined, and the real cause is seldom known or suspected; but in some families, after all the care that is taken in the manufacture of the article, the beer is never palatable or wholesome. – Barrels should be well cleaned with boiling water; and if the bung-hole will admit, they should be scrubbed inside with a hard brush. If they have acquired a musty scent, take out the heads, and let them be well scrubbed with sand and fuller's earth. Then put in the head again, and scald it well; throw in a piece of unslaked lime, and close up the bung. When the cask has stood some time, rinse it well with cold water, and it will then be fit for use. New casks likewise require attention, for they are apt to give the liquor a bad taste, if they be not well scalded and seasoned several days successively before they are used; and old casks are apt to grow musty, if they stand any time out of use. To prevent this, a cork should be put into every one of them as soon as the cock or fosset is taken out; the vent and the bung-hole must also be well closed. The best way to season new casks is to boil two pecks of bran or malt dust in a copper of water, and pour it in hot; then stop it up close, and let it stand two days. When the cask is washed and dried, it will be fit for use.

      BREWING MACHINE. Where a family usually consume ten gallons of beer, or upwards, in a week, there is a Brewing Machine lately invented, which will be found singularly convenient and advantageous, and comparatively of little expense. The use of it in brewing curtails the labour, shortens the time in which the operation may be performed, greatly diminishes the quantity of fuel, and may be placed within very narrow limits, in the house of any tradesman in the most crowded city. Eighteen gallons of good beer may be brewed with this machine in the course